Kenton KADI Port Manuel d'utilisateur télécharger pdf

Instructions for using a CR-78 fitted with the Kenton KADI socket kit

Setting up:

Your Pro-KADI converter should be set up in the following way:

Connect the cable between the Pro-KADI and the CR-78. Connect the power supply to the Pro-KADI and switch

on. Select menu option F (trigger length) and set to 40. (then store by pressing the select button until ST appears)

Note that when the KADI port is connected and the Pro-KADI is on, the CR-78 internal sequencer will not run.

Playing the sounds:

Set the FADE switch on the back panel to ON (down). This allows the sounds to play, otherwise they are muted by

the fade circuit. With a CR-78 set to its default note assignments, you will be able to play the following 10 sounds

C #36 Bass Drum

C# #37 Snare Drum

D #38 Rim Shot

D# #39 HiHat

E #40 Cymbal

F #41 Maracca

F# #42 Clave

G #43 Hi Bongo

G# #44 Lo Bongo

A #45 Lo Conga

_________________________________________________________________________________________

Notes on using the clock input:

If you want to just run the CR-78 in time with MIDI clock, you will need to unplug the 15 pin KADI cable and instead,

connect a lead from the clock output of the Pro-KADI to the clock input of the CR-78.

You will need to set clock divide ratio (menu option H) to 2.

When you start your sequencer, the CR-78 will then play in time with your sequence. You will always have to start

the sequence from the top as the CR-78 will not recognise song position pointers.

Troubleshooting Clock:

1) Ensure that you are using a mono jack lead, not stereo.

2) You need to make sure that the clock output is enabled on your sequencer, this is very often on a setup

page or on a pull-down menu. The clock output on Kenton converters must receive a MIDI start command

before they will output a clock signal, so if your CR-78 doesn't start with your sequencer, check that your

converter is receiving both timing clock and a MIDI start command. Instead of a start command, some

sequencers send a song position pointer zero followed by a continue message, if this is the case, you will need

to set “continue = start” to ON.

3) MIDI sync isn't on any particular MIDI channel, it's on a sort of global channel of its own.

Kenton Electronics www.kentonuk.com

Brookfarm House, Station Road, South Wimbledon, London, SW19 2LP, UK

Tel: 020-8544-9200 Fax: 020-8544-9300

International tel: +44 20-8544-9200 Fax +44 20-8544-9300

Résumé du contenu

Page 1

Instructions for using a CR-78 fitted with the Kenton KADI socket kit Setting up: Your Pro-KADI converter should be set up in the following way:

Commentaires sur ces manuels

Pas de commentaire

Kenton KADI Port Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Équipement Kenton KADI Port. Kenton KADI Port User Manual [en] [de] Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Kenton KADI Port